Skip to main content
lego

Briksmax light kit review: Our Iron Man and Rivendell, lit

β€’Patrick W.

Our Briksmax light kit review after lighting the LEGO Iron Man Mark 3 (76344) and Rivendell (10316): real work to install, superb instructions, a fantastic result. 4.5/5.

The LEGO Iron Man Mark 3 (76344) with the Briksmax 2.0 light kit installed, arc reactor, eyes and repulsors glowing

This post contains affiliate links. We may earn a commission if you make a purchase, at no extra cost to you. As an Amazon Associate, Dadnology earns from qualifying purchases.

This review is part of our LEGO 18+ hub, where every adult LEGO set we have reviewed is collected.

A good LEGO display set looks great on the shelf. A lit one looks great after dark too. We have installed two Briksmax light kits so far, one on the Iron Man Mark 3 (76344) and one on Rivendell (10316), and on both sets the end result looks fantastic. It is not a five-minute job: mounting the lights takes real effort. But the instructions are so well made that everything was clearly explained and easy to follow. That earns Briksmax 4.5 out of 5 from me.

Briksmax makes LED kits for specific LEGO sets: lights, thin cables, connectors, a power supply and instructions that show where each piece goes in that exact model. They are third-party products, not made by LEGO, so check that a kit matches your set number before you buy.

What is in a Briksmax kit

Every kit is made for one specific set, and the contents follow from that. According to Briksmax, the 2.0 kits use enclosed light bricks, which give a softer light than bare LEDs, plus special cable-hider bricks that keep the wiring tidy inside the model. The kits run from a USB power supply or from a battery box, so a lit set does not have to stand next to a socket. Briksmax also lists free replacement parts and direct customer support.

The Rivendell kit is built around warm light and module-by-module installation, so you light the valley one section at a time rather than all at once. That matches what we experienced: the instructions break a big job into small, clear steps.

None of this is LEGO hardware. The kits are made to fit LEGO sets, but they are a third-party product, which is why the right set number on the box matters so much.

The Iron Man Mark 3: What gets lit

The BriksMax 2.0 kit for the Iron Man Mark 3 lights exactly the parts you would want lit. The arc reactor glows ice blue. The eyes glow warm behind the gold faceplate. The shoulder joints and the palm repulsors light up as if the suit is about to take off. And two red LEDs under the display base wash the plaque and the boots in a red glow from below.

Side-by-side comparison of the LEGO Iron Man Mark 3 with the BriksMax light kit switched off and switched on, showing the glowing arc reactor, eyes and palm repulsors
Before and after: the same Iron Man Mark 3, without and with the Briksmax kit.

None of it looks like an aftermarket gimmick. Every light sits where the film puts it, and the kit looks as if the set was designed around it. In our Iron Man Mark 3 review, the set was already a 5/5 without lights; with the kit, it became the best display piece on our shelf.

Installation: Real effort, superb instructions

Mounting the lights is the part to be honest about. It takes time and patience. You work through the set section by section: lift a few bricks, place the LED, route the cable through the existing gaps, put the bricks back, move on. The cables are very thin, which is what makes them disappear inside the model, but it also means you handle them with care.

Close-up macro shot of the BriksMax LED arc reactor ring glowing ice blue in complete darkness
The LED ring that becomes the arc reactor, shot in total darkness during the install.

What makes it work is the instructions. They are very well made: illustrated, step by step, and at every stage it was clear which brick to lift, where the light goes and where the cable runs. Nothing was left to guesswork, so even with all the effort, it was very easy to carry out. On the Iron Man, we never had the whole figure apart at once, and once everything was connected, no cable was visible from any display angle.

Controls: A touch button on the armour

The Iron Man kit has a clever control. The red underglow comes on as soon as the kit has power. The armour lights sit on a touch button at the back of the figure: tap it, and the arc reactor, eyes and repulsors switch on together. Keep your finger on it, and the lights dim up and down, so you can choose anything from a subtle evening glow to full brightness. No app, no remote to lose.

The LEGO Iron Man Mark 3 in near-total darkness with the BriksMax kit on, arc reactor and repulsors glowing and a red underglow illuminating the display base
Lights out: arc reactor, repulsors and the red underglow under the base.

Rivendell: The big project

Rivendell is a different scale. With 6,167 pieces it is one of LEGO’s biggest sets, and lighting it is a project of its own. It was a lot of work: I cannot give you an exact figure, but it took at least five hours. Plan for it like a second build session rather than a quick add-on, and give yourself space on the table for the cables and the instructions.

The instructions were very good here too. Even on a set this size, every step was clear, and nothing had to be worked out by trial and error. And the result is worth it: the lights set the whole valley in scene, with real atmosphere. It is the upgrade that turned our finished Rivendell into the centerpiece of the room. Our Rivendell review covers the set itself.

One practical consequence to know before you start: once Rivendell is lit, it is no longer a set you carry around. With the lights and cables installed, we cannot move it to our photo studio, which is why there are no studio photos of the lit Rivendell here. A lit display set is a set that stays where it stands, so decide where it lives before you install the kit.

What we would light next

Would I light another set? Yes, without hesitating. At the top of my list is our LEGO Avengers Tower, which already dominates the room in daylight.

Is a light kit worth it?

It depends on where the set stands. A light kit pays off on a display set that you see in the evening: in the living room, in a dim office, next to a home cinema. On a set that lives in a bright room or in a cupboard, it adds little.

The effort is the other question. If you enjoyed the build and do not mind spending another evening with the set, a Briksmax kit is the most satisfying upgrade we know for an adult display set. If you want the set finished the moment the last brick is placed, skip it.

We have not compared Briksmax with other brands’ kits on these two sets. What we can say is that both Briksmax kits we installed were clearly explained and looked fantastic at the end.

Pros

  • The result looks fantastic on both the Iron Man and Rivendell
  • Superb, clear, illustrated instructions for every step
  • Lights sit exactly where they belong, cables stay hidden
  • Clever touch control on the Iron Man kit, no app needed

Cons

  • Mounting the lights takes real time and patience
  • A big set like Rivendell is a project of its own: at least five hours
  • A lit set is hard to move afterwards

The verdict

Briksmax light kits are the best upgrade we have found for adult LEGO display sets. Installing them is real work, there is no way around that, but the instructions are so good that every step is clear and easy to follow. And the result is fantastic, on the Iron Man Mark 3 as much as on Rivendell. The effort is the only reason this is a 4.5 and not a 5.

The Final Word: If a display set means a lot to you, light it.

πŸ“Œ FAQ

Are Briksmax light kits worth it?

For a display set you care about, yes. We installed the Briksmax kits on the LEGO Iron Man Mark 3 (76344) and Rivendell (10316), and the result is fantastic on both. Installing them is real work, but the instructions make every step clear. We rate the kits 4.5/5.

Is a Briksmax kit hard to install?

It takes effort, but it is not difficult. You work through the set section by section: lift a few bricks, place the LED and route the cable, put the bricks back. The illustrated instructions show exactly where each light and cable goes. On the Iron Man it took us one relaxed evening; Rivendell took at least five hours.

What does the Briksmax kit light on the Iron Man Mark 3?

The arc reactor, the eyes, the shoulder joints and the palm repulsors, plus two red LEDs that light the display base from below. The underglow is on whenever the kit has power; the armour lights switch on with a touch button on the back of the figure, and holding the button dims them.

Do you have to take the LEGO set apart to install a Briksmax kit?

Not completely. On our Iron Man Mark 3 we only ever removed a few parts at a time, one section after another, and the figure stayed largely built throughout. The thin cables disappear into the gaps between the panels.

Can you still move a LEGO set after installing a light kit?

Not easily. Once our Rivendell was lit, with the lights and cables installed throughout, it was no longer a set we could carry to our photo studio. Decide where a big set will stand before you install the kit.

Which LEGO set would you light next?

The LEGO Avengers Tower (76269). It already dominates the room in daylight, and after the Iron Man Mark 3 and Rivendell it is the set we would most like to see lit.

Is a light kit LEGO-made?

No. Briksmax kits are third-party products made for specific LEGO sets. Always check that the kit matches your set number before you buy.

Patrick W.Founder & Editor

Father of two, keen nature & landscape photographer, and smart-home tinkerer based in rural Germany. Camera gear gets tested outdoors in real conditions β€” not on a studio bench β€” and the house runs on a home network more elaborate than it strictly needs to be. Everything reviewed here has to survive real family life: school runs, sticky fingers, and the odd toddler stress-test. Reviews are never sponsored β€” no paid placements, no press-sample deals. How we test β†’

More about Dadnology

Dadnology Weekly

One email a week: the LEGO, gaming and movie news worth a dad's time β€” plus what we actually reviewed. No hype, no daily spam.

You'll get a confirmation email first. Unsubscribe from any issue with one click. See the privacy notice.

Disclaimer: This review and its visuals were created with the help of AI. Some links may be affiliate links – we may earn a commission if you make a purchase, at no extra cost to you.

Current deals in LEGO

Verified live discounts tracked on Amazon

Explore all LEGO deals

You might also like

Dadnology title card: LEGO Marvel Hulkbuster (76210) review: The ultimate iron armour
LEGOReview

LEGO Marvel Hulkbuster (76210) review: The ultimate iron armour

LEGO Hulkbuster (76210) is a 4,049-piece display monster: a 52cm MK44 Veronica with three light-up arc reactors, a poseable upper body and an opening chest cavity for the separate Iron Man figure. A definitive Marvel display centrepiece and an effortless 10 for Iron Man dads.

The fully built LEGO Iron Man Mark 3 Collectors' Edition (76344) standing on its display base with the exclusive minifigure at its feet, photographed against a dark background
LEGOReview

LEGO Iron Man Mark 3 (76344) review: The perfect Iron Man

LEGO Iron Man Mark 3 (76344) is a 1,297-piece, 38cm brick-built recreation of the hot-rod red Mark 3 armour, with gold-lacquered accents, a poseable body, superb value and a display base. Add the BriksMax 2.0 light kit and it becomes a museum piece. An effortless 10.

Dadnology title card: LEGO 67006 The Marvel Skyline revealed: 1,261 pieces of superhero architecture
News

LEGO 67006 The Marvel Skyline revealed: 1,261 pieces of superhero architecture

LEGO has announced The Marvel Skyline (67006): a 1,261-piece 18+ microscale Architecture-style model spanning Wakanda, Oscorp, and Xavier's School.